Aredale Farm Center - Executive Summary

| Accident History | Chemicals | Emergency Response | Registration | Source | Executive Summary |

Facility: AREDALE FARM CENTER; Aredale, IA 
Contact:Terry Fliehler 
Phone: 515-894-3435 
 
1. Facility Policy. 
 
The owners, management and employees ofAredale Fram Center (the 
facility) are committed to the prevention of any accidental releases of 
anhydrous ammonia.  If an accidental release should occur, the facility is 
prepared to work with the Aredale Fire Department, Butler County LEPC,  
or other authorities, to mitigate and minimize the impacts of the release to 
the people and the environment.   
 
2. Facility Information. 
 
The primary activity at the facility is the storage of fertilizers for sale 
to farmers.  Anhydrous ammonia is received, stored and distributed for 
direct application and for crop production nutrients.  One (1) 30,000 gallon 
Anhydrous Ammonia storage tank is on site. The maximum quantity stored 
at 85% capacity would be 131,146 pounds.    We have Safety and Emergency 
Action Plan in place. We provide our employees with appripriate training for 
handling Anydrous Ammonia 
and responding to accidental releases. We  
update our Programs periodically as needed. Maintenance is performed as  
needed and documented in our files.  In order to evaluate potential accidental 
releases, we performed an off-site consequence analysis using guidance  
from the Fertilizer Institute. 
 
3.Worst-Case Scenario and Alternate Release Scenario 
 
a:     The worst-case scenario would be the release of the total contents of 
the storage tank released as gas over a period of 10 minutes.  The maximum 
quantity released would be 131,146 pounds, which represents the volume of 
the largest storage tank at 85 percent capacity as limited by design 
standards.  The distance to the end point (point of dispersion to 200 parts 
per million, or ppm) is 2.40 miles.   
 
b:    The alternate release scenario, based on the five-year accident history 
(or the most likely potential incident), is a release from a break in a 
3-inch transfer hose followed by release of ammonia for 2 minutes before an 
automatic  
excee flow valve or manual shut-off intervenes and stops the flow of ammonia.  The 
maximum quantity released would be 11908 pounds.  The distance to the 
endpoint (point of dispersion to 200 ppm) is .8 miles.   
 
4.Accidental Release Prevention Program 
 
The facility has been reviewed for general compliance with the provisions 
of "Safety Requirements for the Storage and handling of Anhydrous Ammonia, 
K-61.1", published by The American National Standards Institute, Inc. 
(ANSI), and the standards of the U.S. Occupational Safety and Health 
Administration (OSHA), 29 CFR 1910.111, "Storage and handling of anhydrous 
ammonia".  The ANSI Standard has been adopted by reference by Iowa 
Administrative Code Part 21-Chapter 43-Rule 43.6(200)-Standard for the 
storage and  handling of anhydrous ammonia.  The OSHA standard is 
referenced in the Registration Form Section 8.3.b. 
 
5.Five-Year Accident History. 
 
There have been no accidental releases of anhydrous ammonia in the past 
five years that: have caus 
ed any deaths, injuries or significant property 
damage at the facility; nor to our knowledge, have resulted in off-site 
deaths, injuries, evacuations, sheltering in place, property damage, or 
environmental damage.   
 
6.Emergency Response Program. 
 
The facility has: 
 
a.  An written action plan, in accordance with OSHA standard 29 CFR 1910.38; 
 
b.   Provided state and local authorities with the emergency planning and 
community right-to-know information as required under SARA Title III 
(EPCRA); 
 
c.   This facility is included in the Butler County's  Emergency Response Plan. 
 
 
7.Planned Changes to Improve Safety. 
 
Safety improvement is an on-going process at the facility.  Periodic 
evaluations are performed to assess the maintenance of safe conditions.  
 
There are no additional specific safety recommendations regarding storage 
or use of anhydrous ammonia for implementation at this time.
Click to return to beginning