Farmers Coop Association, Keota,Ia. - Executive Summary

| Accident History | Chemicals | Emergency Response | Registration | Source | Executive Summary |

Risk Management Plan - Executive Summary 
 
Facility:      Farmers Coop Association, Keota, Ia. 
Contact:     Dave Hobscheidt 
Phone:       515-636-3748 
 
1.  Facility Policy. 
 
    The owners, management and employees of Farmers Coop Association (Keota) 
    are committed to the prevention of any accidental releases of anhydrous ammonia and 
    propane.  If an accidental release should occur, the facility is prepared to work with 
    the local fire department, or other authorities, to mitigate and minimize the impacts of 
    the release to the people and the environment. 
 
2.  Facility Information. 
 
    The primary activity at the facility is the storage and blending of fertilizers for sale to 
    farmers.  Anhydrous ammonia is received, stored and distributed for both direct 
    application and for blending into mixed-grade fertilizers for crop production nutrients.   
    Anhydrous ammoia and propane are stored at the facility in four storage tanks 11,000  
    gallons and 26,000 ga 
llons for ammonia; 30,000 gallons and 11,800 gallons for propane. 
    The maximum quanitiy stored would be 157,250 pounds for ammonia and 131,461  
    pounds for propane. 
 
3.  Worst-Case Scenario and Alternate Release Scenerio. 
 
    a.     The worst case scenerio for anhydrous ammonia would be the release of the total 
            contents of a storage tank released as gas over a period of ten minutes.  The  
            maximum quantity released would be 157,250 pounds, which represents the volume 
            of the largest storage tank at 85 percent capacity as limited by design standards.  The 
            distance to the end point (point of dispersion to 200 parts per million, or ppm) is 2.4 miles. 
            For propane the maximum quantity released would be 132,000 pounds.  The distance 
            to the end point (point of 1 psi overpressure) is 0.4 miles. 
 
    b.     The alternate release scenerio for anhydrous ammonia is a release from a break in a 
            3-inch 
transfer hose for 2 minutes before an automatic or manual shut-off intervenes 
            and stops the flow of ammonia.  The maximum quantity released would be 110,500 
            pounds.  The distance to the endpoint (point of pispersion to 200 ppm) is 1.6 miles. 
            The alternate release scenerio for propane is a release from a hose rupture caused 
            by a pull-away and assumes a 25-foot length of 4-inch transfer hose.  The acive 
            mitigation devices are assumed to function as designed, limiting the release to the 
            contents of the hose.  The maximum quantity released would be 94,400 pounds.  The 
            distance to the end point (point of 1 psi overpressure) is 0.4 miles. 
 
4.  Accidental Release Prevention Program. 
 
    The facility has been reviewed for general compliance with the provisions of "Safety 
    Requirements for the Storage and Handling of Anhydrous Ammonia, K-61.1", published 
    by The American National Standards Inst 
itute, Inc. (ANSI), and the standards of the U.S. 
    Occupational Safety and Health Administration (OSHA), 29 CFR 1910.111, "Storage and 
    Handling of Anhydrous Ammonia".  The ANSI Standard has been adopted by reference 
    by Iowa Administration Code Part 21-Chapter 43-Rule 43.6(200)- Standard for the Storage 
    and Handling of Anhydrous Ammonia.  The applicable standard for propane is NFPA-58. 
    The OSHA standard is referenced in the Registration Form Section 8.3.b. 
 
5.  Five-Year Accident History. 
 
    There have been no accidental releases of anhydrous ammonia or propane in the past 
    five years that: have caused any deaths, injuries or significant property damage at the     
    facility; nor to our knowledge, have resulted in off-site deaths, injuries, evacuations, 
    sheltering in place, property damage, or environmental damage. 
 
6.  Emergency Response Program. 
 
    The facility has: 
 
    a.     a written action plan, in accordance with OSHA standard 29 CFR 19 
10.38; 
 
    b.     provided state and local authorities with the emergency planning and community 
            right-to-know information as required under SARA Title III (EPCRA). 
 
7.  Planned Changes To Improve Safety. 
 
    Safety improvement is an on-going process at the facility.  Periodic evaluations are  
    performed to assess the maintenance of safe conditions.  There are no additional 
    specific recommendations regarding storage or use of anhydrous ammonia and propane 
    for implementation at this time.
Click to return to beginning