Iowa Double Circle Olds - Executive Summary

| Accident History | Chemicals | Emergency Response | Registration | Source | Executive Summary |

Risk Management Plan - Executive Summary 
 
Facility:      Iowa Double Circle, Olds, IA 
Contact:     Steve Williams 
Phone:       800-772-2667 
 
1.  Facility Policy. 
 
    The owners, management, and employees of Iowa Double Circle (Olds) are committed to the 
     prevention of any accidental releases of anhydrous ammonia and propane.  If an accidental 
     release should occur, the facility is prepared to work with the local fire department, or other 
     authorities, to mitigate and minimize the impacts of the release to the people and the environment. 
 
2.    Facility Information. 
 
      The primary activity at the facility is the storage and blending of fertilizers for the sale to farmers. 
       Anhydrous ammonia is received, stored, and distributed for both direct application and for 
       blending into mixed-grade fertilizers for crop production nutrients.  The maximum quantity stored 
       would be 204,000 pounds of ammonia and 56,600 pounds of propane. 
 
3.      Worst-Case  
Scenario and Alternate Release Scenario 
 
         a.     The worst-case scenario would be the release of the total contents of a storage tank 
                  released as gas over a period of 10 minutes. 
 
                  Anhydrous Ammonia- The maximum quantity released would be 76,500 pounds, which 
                  represents the volume of the largest storage tank at 85 percent capacity as limited by 
                  design standards.  The distance to the end point (point of dispersion to 200 parts per 
                  million, or ppm) is 2.1 miles. 
 
                  Propane- The maximum quanitity released would be 56,000 pounds.  The distance to the 
                  end point (point of 1 psi overpressure) is 0.3 miles. 
 
         b.      The alternate release scenario, based on the five-year accident history (or the most 
                  likely potential incident), is as follows: 
 
                  Anhydrous Ammonia- The alternate release scenario is a release from  
a break in a 
                  3-inch transfer hose followed by release of ammonia for 2 minutes before an 
                  automatic or manual shut-off intervenes and stops the flow of ammonia.  The 
                  maximum quanitity released would be 26,600 pounds.  The distance to the 
                  endpoint (point of dispersion to 200 ppm) is 1.6 miles. 
 
                  Propane- The alternate release scenario is a release from hose rupture caused by a 
                  pull-away and assumes a 25-foot length of 4-inch transfer hose.  The active 
                  mitigation devices re assumed to function as designed, limiting the release to the 
                  contents of the hose.  The maximum quantity released would be 69 pounds.  The 
                  distance to the end point (point of 1 psi overpressure) is 0.03 miles, or 175 feet. 
 
4.       Accidental Release Prevention Program 
 
         The facility has been reviewed for general compliance with the provision 
s of "Safety 
         Requirements for the Storage and Handling of Anhydrous Ammonia, K-61.1", published 
         by The American National Standards Institute, Inc. (ANSI), and the standards of the U.S. 
         Occupational Safety and Health Administration (OSHA), 29 CFR 1910.111, "Storage and 
         Handling of Anhydrous Ammonia".  The ANSI Standard has been adopted by reference by 
         Iowa Administrative Code Part 21-Chapter 43-Rule 43.6(200)-Standard for the storage 
         and handling of anhydrous ammonia.  The applicable standard for propane is NFPA-58. 
         The OSHA standard is referenced in the Registration Form Section 8.3.b. 
 
5.       Five-Year Accident History 
 
         There have been no accidental releases of anhydrous ammonia or propane in the past five 
         years that: have caused any deaths, injuries, or significant property damage at the facility, 
         nor to our knowledge, have resulted in off-site deaths, injuries, evacuations, shelteri 
ng in 
         place, property damage, or environmental damage. 
 
6.       Emergency Response Program. 
 
         The facility has: 
 
         a.     a written action plan, in accordance with OSHA standard 29 CFR 1910.38; 
 
         b.     provided state and local authorities with the emergency planning and community 
                 right-to-know information as required under SARA Title III (EPCRA). 
 
7.       Planned Changes to Improve Safety. 
 
         Safety improvement is an on-going process at the facility.  Periodic evaluations are 
         preformed to assess the maintenance of safe conditions.  There are no additional specific 
         safety recommendations regarding storage or use of anhydrous ammonia and propane for 
         implementation at this time.
Click to return to beginning