W.B. Johnston Grain - Wakita, Oklahoma - Executive Summary

| Accident History | Chemicals | Emergency Response | Registration | Source | Executive Summary |

Risk Management Plan  
Executive Summary 
W.B. Johnston Grain Co Wakita 
 
 
Certification for the Risk Management Plan Program 2, Anhydrous Ammonia 
 
To the best of the undersigned's knowledge. The following information 
submitted is true, accurate and complete. 
 
Billy Zane Jones                             Billy Zane Jones 
 
Manager                                          
 
 
A risk management plan has been implemented at Johnston Grain Company's 
Wakita facility to provide a contingency plan in the event of accidental release of 
anhydrous ammonia. This plan has been developed to prevent accidental release 
through responsible handling and proper storage of the product. Johnston's will 
also ensure that employees receive the necessary training and that proper safety 
equipment is provided. Johnston's will also make sure that the surrounding 
community is aware of our preparedness in the event of an accident. 
 
Johnston's Wakita facility is a full service, country elevator, which sell feed, seed 

fertilizer, as well as agricultural chemicals. The only substance subject to regulation 
under RMP and above the threshold quantities is anhydrous ammonia. Anhydrous 
ammonia is received, stored and distributed from our facility as a crop fertilizer only. 
Our facility has one storage tank that has  12,000  gallons capacity 
and is filled only 85%, this equals  56,000  pounds of ammonia. We also have 
( 21 ) l000 gallon Nurse tanks also filled to a maximum of 85% full at our location. The 
combined capacity of all tanks at this location   33,000   gallons or  154,110 
pounds of anhydrous ammonia. 
 
This facility has a site safety coordinator", all Johnston coordinators are given training 
to monitor the day to day safe work activities, maintain the required regulatory record 
keeping, conduct safety meetings, conduct employee training and act as the location's 
contact with the corporate office. The site safety coordinator acts as the location's 
emergency contact. 
 
As required by EPA guidelines 
the following worst-case release and alternative release 
scenarios have been devised. 
 
 
Worst Case Scenario: 
 
 
 
Our worst cast scenario is the loss of the total contents of  12,000  gallon storage 
tank, when filled to the greatest amount allowed (85% of capacity), released as a gas 
over l0 minutes, resulting in total vaporization. The maximum quantity released would 
be  56,000 pounds. According to DEGADIS modeling, this release (distance from point 
of dispersion to 200 PPM) would have off-site impacts and would travel 0.84 miles. 
It should be noted that Johnston's has never had a release of an entire stationary 
anhydrous ammonia storage tank from any of facilities. 
 
Alternative Release Scenario: 
 
The most common alternative release scenario from our facility would be in the failure of 
a 1-inch transfer hose and release of approximately 2901 pounds of anhydrous ammonia 
over a two-minute period. Under the worst weather conditions the contents would travel 
.22 miles before dispersing eno 
ugh to no longer pose a hazard to the public. It should be 
noted that Johnston's has not had a release of this type from any facility in the past. 
 
General Accidental Release Prevention Program and Chemical-Specific 
Prevention Steps: 
 
The anhydrous ammonia system is designed, installed and maintained in accordance 
with ASTM standards and ASME codes. This facility complies with the ANSI K61.1 
standards, OSHA (29 CFR 1910.111), EPA's Accidental Release Prevention Rule and 
all applicable federal, state and local codes and regulations. 
 
Our ammonia system is protected from major releases by internal excess flow valves, 
check valves, relief valves and manual shutoffs. The load-out risers used for the purpose 
of filling the nurse tanks are protected by excess flow valves to stop the flow of ammonia 
in a line or hose fails. All main storage tank valves are locked when not in use. 
 
Our ammonia facility is inspected on a regular basis with maintenance and preventative 
maintenance scheduled and  
documented. Liquid and vapor valves, hoses excess flow 
valves, gauges and relief valves are replaced when necessary and according to the 
guidelines in the ANSI standards. 
 
Training is provided to all employees at least annually, whenever there is change in the  
process or whenever competency with the regulations is questioned. The training 
consists of classroom lecture, current videos, testing and certification and on the job 
training. 
 
Five Year Accident History: 
 
There have been no accidents involving anhydrous ammonia that caused deaths, injuries, 
property or environmental damage, including evacuations on or off site. 
 
 
Emergency Response Program: 
 
In the event of an emergency involving our ammonia system, it is our policy to notify the  
local community fire department and request that they respond to the emergency. In 
preparation for this, we have coordinated with all of the local agencies by providing 
information and offering tours to ensure that they are familiar with and are pro 
perly 
prepared for an incident at our facility. This will help ensure that the community has the 
strategy for responding to and mitigating the threat posed by an ammonia release. This 
complies with the requirement for our facility to be included in the community  
emergency reponse plan prepared under EPCRA and coordinated with our LEPC. 
 
Johnston Grain has an Emergency Reponse and Contingency Plan for our facilities that 
include provisions for public notification, initial medical care, evacuations and LEPC 
coordination. 
 
Planned Changes to Improve Safety: 
 
We do not plan to make any changes to the physical site. We will continue to provide 
our employees with ongoing annual training to ensure that they are current with safe ammonia  transfer and handling procedures. We will also provide regular inspection and maintenance 
on all of the ammonia equipment.
Click to return to beginning