Heinz Frozen Food Company, Ontario - Executive Summary

| Accident History | Chemicals | Emergency Response | Registration | Source | Executive Summary |

                       Heinz Frozen Food Company 
               Ontario, Oregon Food Processing Facility 
 
                      EPA Risk Management Program 
                           Executive Summary 
 
 
1.   Accidental Release Prevention and Emergency Response Polices 
 
Heinz Frozen Food Company s (HFFC) manufacturing sites comply with applicable federal, state 
and local regulations.  As with all HFFC manufacturing locations, this food processing facility has 
a formal worker safety program.  All employees are informed of hazards in the workplace.  
Employees who work with potentially hazardous substances receive proper training in the 
handling of those substances.  This facility has procedures in place to safely remove employees 
from areas in the unlikely event that a hazardous substance release were to occur, and to put in 
place emergency notification and response procedures. 
 
 
2.   Facility and Regulated Substances 
 
This Heinz Frozen Food Company food processing facility is located at 175 N.E. 6th Avenue, 
Ontario, Oregon.  Frozen prepared foods are produced at this location.  Food ingredients are 
received, washed, peeled, cut, blanched, fried, frozen and packaged.  The regulated substance at 
this facility, anhydrous ammonia, is used in a closed-loop refrigeration system for product cooling 
and freezing. Ammonia is the most effective, energy efficient and environmentally safe chemical for 
keeping food at it's proper temperature. 
 
3.   Worst-Case and Alternate-Case Release Scenarios 
 
The worst-case scenario consists of the release of ammonia from the largest vessel over a period 
of ten minutes.  The maximum quantity of ammonia in the vessel is limited to 30-percent of the 
total volume of 35,800 pounds via written administrative controls, resulting in a release of 
approximately 11,000 pounds of ammonia.  There are off-site impacts under this worst-case 
scenari 
o. 
 
The alternate-case scenario consists of the release of ammonia vapor from a safety relief valve due 
to an overpressure condition in a vessel located in the facility s machine room.  The relief valve is 
designed to vent ammonia to the atmosphere when its pressure rating is exceeded, preventing 
potential damage to other components in the refrigeration system.  The scenario results in a 210- 
pound ammonia release over a period of 11 minutes.  There are no off-site impacts under the 
alternate-case scenario. 
 
If an accidental release of ammonia occurs, an Incident Investigation Team is mobilized to determine 
the root cause of the release. The team develops corrective actions to prevent similar releases in the 
future. 
 
4.   General Accidental Release Prevention Program and Ammonia Specific Prevention 
 
All Heinz Frozen Food Company manufacturing locations comply with the OSHA Process Safety 
Management for Highly Hazardous Chemicals (PSM) standard relative to anhydrous ammonia.  
Therefore, 
this facility has programs to ensure proper operation and maintenance of the ammonia   
refrigeration system.  Further, refrigeration system operators have been trained and are 
knowledgeable in the safe operation of the refrigeration system. 
The ammonia refrigeration system at this facility has been designed and constructed using good 
engineering practices and to conform to industry standards.  The system includes ammonia 
detection devices,high- and low-level switches in pressure vessels, and safety relief valves to  
avert serious system overpressure.  Periodic maintenance on the refrigeration system is ensured  
via the use of a computerized maintenance management system.  Annual physical system audits are  
performed by an external refrigeration contractor to ensure system integrity.  
 
5.   Five Year Accident History 
 
During the past five years this facility has had no significant accidental releases of ammonia. 
 
6.   Emergency Response Program 
 
This food processing facility has proced 
ures in place to respond to the release of a hazardous 
substance.  Employees are trained to evacuate their respective areas in accordance with OSHA 
1910.38(a).  Specific employees are designated and further trained to respond to a release in 
accordance with OSHA 1910.120(q).  Coordination with the local fire department and LEPC is 
initiated during an emergency situation.
Click to return to beginning