Western Farm Service, Roberts - Executive Summary

| Accident History | Chemicals | Emergency Response | Registration | Source | Executive Summary |

Agrium / Western Farm Service 
Roberts Facility 
 
 
1.  Facility Accidental Release Policy 
 
The owners, management, and employees of Western Farm Service's Roberts facility (herein referred to as the Facility) at 272 North Bassett Road, Roberts, Idaho, 83444 are committed to the prevention of any accidental release of anhydrous ammonia, aqua ammonia, and propane.  If an accidental release should occur, the facility is prepared to work with the local fire department, or other authorities to mitigate any release and minimize the impact of the release to people and the environment.  A detailed emergency response plan has been developed and will be implemented in the event of an accidental release. 
 
2.  Facility Information 
 
The primary activity at the Facility is the storage, blending, and sale of fertilizers, in addition to, the sale of pre-packaged agricultural chemicals to farmers.  
 
Anhydrous ammonia is received, stored, and distributed for blending into mixed grade fertilizers for crop  
production nutrients.  Anhydrous Ammonia is also used in the production of aqua ammonia and ammonium polyphosphate fertilizer. 
 
Anhydrous ammonia is received and stored in one 80-ton rail car and stored in one 12,000-gallon storage tank (bullet) at the site.  The maximum quantity of anhydrous ammonia handled in this process is 188,530 pounds. 
 
Aqua ammonia (upto 30% of ammonia by weight) is produced and stored at the site using an aqua ammonia convertor and stored in one 12,000-gallon above ground tank at the site. The maximum quantity of aqua ammonia handled is 90,000 pounds.  The total quantity of ammonia present in the aqua ammonia, based on 30% active ingredient by weight, is 27,000 pounds.   
 
Propane gas is received by tanker truck and stored in one 5,000-gallon and one 1,400-gallon above ground tanks at the site. 
 
3.  The Worst-Case Release Scenario and Alternative Release Scenario 
 
A.  Anhydrous Ammonia Worst-Case and Alternative Release Scenarios   
The worst-case release scenar 
io is failure of the largest storage tank when filled to the greatest amount releasing 136,000 pounds of anhydrous ammonia, which represents the volume of the largest storage tank at 85% capacity as limited by regulations.  The distance to the endpoint (point of dispersion to 200 ppm) is 2.65 miles.   The alternative release scenario, based on the PHA scenarios (or the most likely potential incident) and  is a release of 11,908 pounds of anhydrous ammonia from a broken 2-inch diameter pipe.  The distance to the endpoint (point of dispersion to 200 ppm) is 1.18 miles. 
 
B.  Aqua Ammonia Worst-Case Release Scenarios   
The first alternative release scenario is failure of the largest storage tank when filled to the greatest amount would release 90,000 pounds of aqua ammonia solution.  The distance to the endpoint (point of dispersion to 200 ppm) is 1.32 miles.  The second alternative release scenario, based on the PHA scenarios (or the most likely potential incident) is a release of 10,000  
pounds of aqua ammonia solution from a storage tank modeled with an increased wind speed and "D" Stability modeling parameters.  The distance to the endpoint (point of dispersion to 200 ppm) is 0.19 miles. 
 
C.  Propane Worst-Case and Alternative Release Scenarios.   
Failure of the largest storage tank when filled to the greatest amount would release 25,250 pounds of propane.  It is assumed that the entire tank contents are released as a vapor which finds an ignition source.  Ten percent of the released quantity is assumed to participate in a resulting explosion.    The distance to the endpoint for the worst-case release scenario is 0.20 miles.  The alternative release scenario, based on the PHA scenarios (or the most likely potential incident) is a  pull-away failure of a 1-1/4-inch diameter pipe with a subsequent vapor cloud explosion. The distance to the endpoint for the alternative release scenario is 0.10 miles.  
 
4.  Accidental Release Prevention Program 
 
Anhydrous Ammonia and Aqu 
a Ammonia:  The Facility has implemented the provisions of the "Safety Requirements for Storage and Handling of Anhydrous Ammonia, K-61.1", published by the American National Standards Institute, Inc.; and the standards of the U.S. Occupational Safety and Health Administration (OSHA), 29 CFR 1910.111, "Storage and Handling of Anhydrous Ammonia." 
 
Propane:  The facility has addressed fires and explosions that could result from a propane release in their Emergency Response Plan.  
 
5.  Five-year Accident History 
 
a. There have been no accidental releases or near misses of anhydrous ammonia or aqua ammonia in the past five years that: 
 
1.  Have caused any deaths, injuries, or significant property damage at the facility; nor 
 
2.  Have resulted in off-site deaths, injuries, evacuations, sheltering in place, property  damage, or environmental damage. 
 
6.  The Emergency Response Program 
 
The facility's emergency response program was written in accordance with the following regulations: 
 
OSHA 2 
9 CFR 1910.38; 
 
OSHA 29 CFR 1910.120; and 
 
7.  Planned Changes to Improve Safety 
 
Safety improvement is an on-going process at the facility.  Periodic evaluations are performed to assess the maintenance of safe conditions.  Specific planned changes to the anhydrous ammonia, aqua ammonia, and propane processes at the facility are listed in the Facility PHAs. In summary, planned changes address the review and development of Standard Operating Procedures for regulated onsite processes.
Click to return to beginning